Current visitors

Home
Members

jerryjerry05's latest activity

jerryjerry05 posted the thread No spark?? F9. 9SMHB 4stroke in Yamaha & Suzuki Outboards.

2013 4st. 9.9 F9.9SMHB 1035097 No spark either cylinder. Test procedures? Thanks,Jerry

Wednesday at 5:34 AM
jerryjerry05 replied to the thread 1990 Force 120HP carbs mix adjustment help.

Plugs: all 4 burn the same color.

Mar 31, 2024
jerryjerry05 replied to the thread 1990 Force 120HP carbs mix adjustment help.

If it's idling ok?? Then why adjust the air screws? Doing the test with starting fluid will insure the air screws are set right...

Mar 30, 2024
jerryjerry05 replied to the thread 1990 Force 120HP carbs mix adjustment help.

750-800 in gear. Trouble setting idle: start the motor, spray starting fluid around the intake side of the motor. Under the coils/packs...

Mar 29, 2024
jerryjerry05 replied to the thread 1984 125 force outboard.

The dog just slides back and forth. The shift rod that goes through the front of the drive can get stuck or sticky because of corrosion...

Mar 17, 2024
jerryjerry05 replied to the thread So close =].

IF??? you have a solid needle??? you have to have an o-ring in the seat. Look close??

Mar 17, 2024
jerryjerry05 replied to the thread So close =].

The Force carbs/seats came 2 ways. #1 came with a solid seat and a needle with a rubber tip. #2 came with a solid needle and a seat with...

Mar 15, 2024
jerryjerry05 replied to the thread 1984 125 force outboard.

Unhook the shift cables(yes both) then try shifting by hand. You'll need to spin the prop as you try to shift. Without spinning the...

Mar 15, 2024
jerryjerry05 replied to the thread Looking for some help.

Like Racer suggested: check the flywheel key and then try starting fluid?

Mar 15, 2024
jerryjerry05 replied to the thread 1999 Force/Merc 75HP 3 Cylinder 2-Stoke Rough Running Issues.

Pinch off the hose going to the primer after it's started. Then spray starting fluid around the intake side of the motor, this includes...

Mar 10, 2024
jerryjerry05 replied to the thread Leg Length 1989 Force 85HP.

The 85 90 120 125 150 all came in 2 lengths. 20 and 25 inch. Google measuring transom for motor length.

Mar 8, 2024
jerryjerry05 reacted to lgaytan's post in the thread Leg Length 1989 Force 85HP with Like.

transom measures 20", so that means I need a long leg motor 20" I guess? thanks

Mar 8, 2024
jerryjerry05 replied to the thread 1991 Force 120HP tilt/trim help.

You add fluid when the T@T is in the down position. Adding while up, can cause lots of damage. HOW?? did you add fluid? Only going up...

Feb 28, 2024
jerryjerry05 reacted to Nordin's post in the thread Black oil in pick up tube and water pump. with Like.

Nothing to worry about, it is unburned fuel. Maybe you carb setting is a little to rich but that is better then to lean. When idling the...

Feb 22, 2024
jerryjerry05 replied to the thread Black oil in pick up tube and water pump..

The lower unit has small holes for the drippins to exit the motor. Make sure they are clear.

Feb 19, 2024

Show older items

Home
Members

Top