Been working an this '85 Evinrude 115 VRO (double carburetor) for a few months now. It wasn't started for three years so I've had a few bugs to chase out. I've been able to get the thing started a few times now and run consistently (although it took some finesse to get started). I finally...
Re: UV damaged gel coat. How do I get that shine & sparkle back?
I just threw some vaseline on there and have been letting it sit in the sun for a few hours... looking pretty sexy, I might just go the poor mans route and not risk cutting through the clear coat. Vaseline, then I'll clean it off...
Re: UV damaged gel coat. How do I get that shine & sparkle back?
Thanks everyone for the replies.
Here's a picture of a spot that was covered
Yes, you're right it's the 1985 Phantom Bass Boat. There are some spots on the back that are spider cracked from extended sun exposure.. Call me...
Previous owner let her sit under the west TX sun for about three solid years and the finish on the boat has turned rather dull. There were a couple areas that were covered up and if you look at those areas, there is a real nice shine and sparkle. Is it possible to restore the sun damaged coat...
It's an Evinrude 115 1985 Phantom Bass boat. The old fella I took this off hadn't started it in three years, but when he shut it down, it ran fine. Now, there is no compression in the number 1 cylinder, the gas gauge reads pretty low, and the oil is super old. I took it down to the dock and...
