The iboats forum moderators are excited to announce that at this time it appears the iboats forums posting pictures function is working once again. Though we cannot promise for how long, we're hoping for indefinitely.
Hello:
I have a King model 1350 Fish Finder. Does anyone know where I may get a manual for this instrument?
Thanks so much for your time. I appreciate it.
Hello:
I have a 1978 Cruisers Yachts Gran Bateau. It has a 283 ci 225 HP engine and an OMC sterndrive. I wanted to make sure the engine runs while the boat is on the trailer. I attached a pair of muffs to the water inlet on the lower gearcase and removed the water hose from the bottom of the...
I have an OMC sterndrive on a 1978 Cruisers Yachts Gran Bateau. When trying to start the engine with the intake cooling water hose disconnected from the stern drive there is no water being pumped out of the stern drive hose nipple. Is this normal and does the water begin to pump when the engine...
Last year I purchased a 1978 Cruisers Yachts Gran Bateau to rebuild. All has been going fairly well. However, I cannot figure out how the upholstered panels go on the transom inside the boat. There are 2 panels the full width of the transom (72") and each about 12 inches high. There are also 2...
I have a 1978 Cruisers Yachts Gran Bateau with a 75 gallon fuel tank. I removed the anti siphon fitting and then the 90 degree elbow the anti siphon fitting threads into. This elbow was threaded into the tank but when I removed it, there was not a tube attached. However, looking into the...
Good afternoon:
I recently purchased a used 1978 Gran Bateau Model 246. Most of the interior had been removed by a previous owner who doesn't recall how everything went back together. Does anyone have any pictures of the interior, especially the aft portion showing where all of the upholstered...
Does anyone have or know where I can get a wiring diagram for the three solenoids at the rear of a 11978 Gran Bateau 305? When I recently bought the boat, 2 of the solenoids had three wires coming off each of the 2 posts on the 2 solenoids. I know the third solenoid is a starter solenoid and the...
Hello:
I have a 1978 OMC stern drive 305 ci engine. I need the choke coil, cover, and rod that goes from the coil to the carb. This coil is one that bolts directly onto the intake manifold. The manifold is a Holley and the carb is a Rochester Quadra jet model 17057290. Can anyone tell me where...
I recently purchased a 1978 Cruisers Yachts Gran Bateau. In the engine compartment, there is a bilge blower which I replaced and the black 4 inch flexible hose attached to this runs down into the bilge area. On the top left and right at the rear on top there is a plastic louvered vent. On the...