We have recently worked on this a bit more.
One thing commented on on some forums is seeing the tach move when cranking -(like to 300 PRM) - We see no movement upward --- even perhaps the smallest downward movement. Is this telling us something since i know the engine must see and RPM to fire??????
We have recently worked on this a bit more.
One thing commented on on some forums is seeing the tach move when cranking -(like to 300 PRM) - We see no movement upward --- even perhaps the smallest downward movement. Is this telling us something since i know the engine must see and RPM to fire??????
We have been working on a problem that was intermittent, but now is permanent.
We have a crank but no start. We feel we have fuel and we have a signal at the injectors. (by noid) We do not think we have spark at the plugs.
We have checked the Crankshaft Position Sensor visually but not checked...
I have that connector drawing, and more -- I am looking for confirmation of which pins to connect for the run circuit and which for the start circuit
thx Dale
I have a 2003 Volvo Penta 5.7 Gi-C I would like to run without the 10 pin connector connected.
I did this in the past when I was rebuilding the engine several years ago but have forgotten which pins to connect on the engine 10 Pin connector to do this.
If I remember correctly with I connect Pin...
I have a Four WInns with a 2003 VP 5.7Gi-C duoprop
I have traced an intermittent fuel pressure issue to the connector on the low pressure pump.
Sometimes I get the required 50 PSI but other times I only get 10-20 PSI.
The connector on the fuel pump side is not replacable, and the male pins on...
This is primarily an informational post on what I have done to correct a leak on a Volvo Penta Steering Ram.
I have attached a picture of my type of steering ram (not my actual one) for reference.
Mine has part number 3862210 on it -- I understand there are many others that are similar. A...
I have just installed a rebuilt shortblock in a 2003 5.7Gi-C.
It runs fine on muffs to any RPM.
On the sea trial it did not develop enough power to get on plane.
I have solved a fuel pressure regulator problem I found, but have also been checking out the fuel pump.
This has the regular fuel cell...
I am rebuilding a 2003 5.7GI-C engine -(serial 4012080761) - and am installing the engine circulating pump.
On the water pump there is a small passage on the fuel pump side that is not on the alternator side.
The old block had a passage where this went into the block.
On the new reman...
Are any of the electric brakes suited for occasional saltwater -- but mostly fresh water use.
I know there have been improvements over time in the electric brakes.
I want to get a tandem trailer with a small SUV below -- and a boat above --- boat weight 2000 lbs -- SUV weight 3700 --- trailer...
I am rebuilding a Volvo 5.7Gi-C. The dip stick goes into the fitting in the bottom of the oil pan. My question is this, what does Volvo use to plug the hole in the block where the dipstick would go in an automotive application? It looks like a soft plug perhaps? I do not see where they...
Can someone give me the proper volvo penta part number for this sensor
The Volvo Penta iboats parts diagrams don't seem to have the correct identification
just to clarify === engine is 2003 5.7Gi-C
multiport fuel injection
uses a thermistor at the thermostat housing -- provides a variable...
I know I used to be able to find them on the transom assemblies on web sites with exploded drawings but they seem to have changed the drawings and I cannot locate the transom assemblies at either iboats, or Doug Russell.
I need to know the correct Gimbal Bearing as well as a good source ---...