Anyone know which part i need from iboats to replace the stator coils in this motor. The only part i see on there for this HP and year is a single coil with 2 wires... i need 2 coils, 1 with 2 wires and another with 1 wire. These wires go to the rectifier.
i have a 25hp electric start evinrude that stopped starting on me. The starter motor pops up but just doesnt have enough juice to turn the motor over. Im only getting 12.07 volts on the battery when the motor is running. Anyone know where the alternator is on these motors or how to test it?
I need to get my trailer weighed so i can register it as homemade... Has anyone in florida ever done this? Does it have to be done at a DOT station or can i do it at a recycling or scrap place?
I bought a 15' aluminum boat, motor and trailer for $450 about 6 weeks ago. The owner signed the title over to me and it had no liens. I went to get it registered and the tax collector told me i HAD to have a bill of sale to get it registered. I have bought and sold a lot of jetskis and never...
i took the foot off my 87' 25hp evinrude and now it is stuck in reverse. It wont go into neutral and when the throttle is applied forward the motor goes backwards. pulling the throttle to the normal reverse is very tough. i can see that the shift rod is not going down as far as it should but i...
I took the foot off my 25hp evinrude to rebuild the water pump and now i want to change the oil in the LU. Anyone know how much goes in there? its an 87 e25euca or e25ecua.
I am trying to get the foot off the motor to rebuild the water pump. All the fixing bolts are off and its dropped down about half an inch. Any trick to getting leverage to pull it off? its very awkward to pull on with level force.
My 87 electric start 25hp evinrude still wont start. I just installed the carb rebuild kit with new needle and seat and i adjusted the float. It still does the same thing its been doing for 3 weeks. It shutters and puts out white smoke and now it backfires a lot and the plugs are wet every time...
anyone know where i can get 1 cheap? a barb on mine pulled out and it leaks like crazy. $160 from evinrude... im not paying that. Or is there anyway to bypass it?
i have a 25hp evinrude with a single needle carb. No matter wut i do with the needle the engine just smokes and studders and when i pull the plugs they are soaked with fuel. I have cleaned and rebuilt the carb. Im thinking this is gonna be a needle and seat problem inside the bowl? does this...
i have an electric start evinrude that wont start. Im getting ignition and the motor shutters and puts out smoke but it wont start. Has plenty of spark and its getting fuel. could it be a timing problem? it was just runnin 2 weeks ago and now this.
I have an 87 evinrude 25hp. i just ran 2 weeks ago. now it will kick like its trying to start and i will get white smoke but it wont start. Its got some wierd looking spark plugs in it (autolite) i think they might be the problem.
I picked up a 15' fisher with a side console. I had to gut the whole thing and put a new floor in. Im in the process of hooking up the new electrical system. I ran main leads up to the console where i have a ground board and a hot lead board with fuses. i have my bilge pump and livewell pump on...
I just bought a boat with an evinrude 25 (e25ecua) im pretty sure its missing the air box since there is nothing attached to the front of the carb... i can see the butterfly valve. I havnt seen it listed in any parts diagrams online. anyone know the part # or where i can get 1?
I just bought a boat with an evinrude 25 (e25ecua) im pretty sure its missing the air box since there is nothing attached to the front of the carb... i can see the butterfly valve. I havnt seen it listed in any parts diagrams online. anyone know the part # or where i can get 1?
