I have a 1986 Evinrude 30hp. It is getting an ittermitent spark. Yesterday I went out and tried to start it and nothing happened. I pulled the plugs out and did a spark test and there was nothing. Then I tinkering around with the engine and tried a spark test again and I got a nice spark. Put...
I have a 86 rude 30hp electric start and I think the gas I ran into the engine has water in it. How can I drain the gas out of the system so I can have new gas ran through??
I have an 1986 evinrude 30 hp. It is hard to start. When it start it will warm up but wont Idle. Could this be becuase I just hooked up the controls.. Also Where is the start position on the warm up lever??? Thanks....
Is is possible to hook up single lever controls to my outboard. The shift lever is on the one side and the throddle lever on on the left. They are not connecected in any way. Do I need dual lever controls? Is there a kit for the single lever? Thanks Dan
which control cable goes where? One cable that is attached to the warm up lever and the other cable is attached to the throddle. My motor has the gear shift lever on the left side and the throddle assembly on the left. I dont understand what goes where. Please assist. Thanks in advance...
What kind of controls do I need for my 1986 evinrude 30hp. The throddle linkage is on the right side of the outboard(looking from inside the boat) and the Forward - reverse lever is on the left. Will any controls work?? Thanks :confused:
Just bought used OMC controls from Ebay. I have a 1986 30hp outboard. The controls are black with 2 control cables and one power cable with red plug. There are also two other plugs hanging of of power cable. This is what I dont get. My motor has on one side a lever for the forward and reverse...
Which battery do I hook mt lights up to? The cranking battery or the deep cycle battery. DO I need some kind of regulator or can I hook it directly to the battery with a switch?
evinrude outboard and steering?
I have a 1986 30hp evinrude and a carolina skiff. I just had the center console installed with teleflex steering. I have to pick up the boat tomorrow and I just want to know how hard it is to hook up the steering? I have the steering rod that hooks to the motor...
I just snapped a piece of the starter housing trying to tighten my flywheel nut. I should of put the screwdriver on the gear spindle. Instead I used a piece of the housing that was sticking up behind the gear. I doesnt look like it does anything. Will everything still work? Can the white metal...