Trying to replace the screen/filter in the fuel bowl. I have the right part number (verified) but, it seems to small in diameter to fit over the nipple. I've tried spraying with oil and heating with a hairdryer with no luck. I can get it up far enough on the nipple then have the bowl hold it in...
After resealing the lower unit and replacing the impeller I now cannot get the lower unit/driveshaft into the powerhead. Made a very bad rookie mistake by moving not only the driveshaft but the powerhead as well. Have tried several "fixes" no luck. Without going through them does anyone have any...
Ordered/rcd new screen/filter for motor from Marine Engine. It is way too small. Double checked part number which is correct. Can anyone give me a number or source for the proper sized screen/filter. Thanks.
This project started as a simple impeller change on my 1964 Evinrude Fastwin 18 hp. Found water in gearcase opened up the gearcase and everything looked very good except the shift rod gasket and bushing (leak) and the seal/cover on the gearcase head assy. Decided to install reseal kit (ordered)...
Trying to replace the impeller on a 1964 evinrude fastwin 18 hp. I've taken the five bolts out and the unit dropped slightly but when I removed the lower bolt/screw on the shift linkage the unit will not come loose or out of the housing. Sprayed oil on and cleaned around the area (some carbon...