I wanted to share this information with you if anyone is having trouble with the route feature on their Motor Guide Xi5 with pin point GPS. Everything works on mine except the route feature. I contacted tec. support, and they said there is a known problem, and their engineers are working on...
I am replacing the shaft on my Motor Guide ix5 trolling motor. What would you recommend using on the threads of the shaft to keep the water out of the motor. Thanks...
My trolling motor is 24 volt, is there a way I can charge the batteries with a battery charger without having to remove the cables from the batteries and charging them separately? Thank you...
Thanks everyone, I appreciate all your help. Never thought about grinding off the bolt heads and removing the manifold for better access to the bolt stud. Thanks again everyone.
I have a 1993 merc. cruiser 4.3L I have to replace the manifold on one side and I am afraid of breaking the bolts. I have applied quite a bit of pressure to the point I am afraid they might break off, so I quit before I snapped one off. Any suggestions? I appreciate anyone's help. Thanks...
Do your plugs have to be indexed? On some motors the plugs have to be indexed and if they aren't indexed correctly your engine will not perform properly. Just sayin'
I have a 1999 50hp 4-stroke (Model#50ELPT4S) (Serial#0G773202) Motor runs great but starts hard when cold. Is there a test procedure to test the Auto Start Assembly (Electro Thermal Plunger) part#825106T Also is there a way to test the Solenoid Coil part#97685T I would greatly appreciate...
