Recent content by bigd6223

  1. B

    Nissan NS5B re-attaching lower unit

    Replaced the water pump impeller on my 1990 5 HP 2 stroke and that went smoothly. When I went to re-attach the lower unit, hooked up the linkage no-problem and inserted the drive shaft into the engine where it would turn then motor over but still needs to go up another inch to insert the bolts...
  2. B

    1990 Zodiac MK1 Stringers

    Just purchased a used 1990 Zodiac MK1 without stringers for the 5 piece wooden floor thinking that it was somethin that I could order. Have not been able to find them online and an online dealer told me that there was nothing that old available. Looking at Diagrams for the current models they...
  3. B

    83 200 hp Blackmax ignition switch install help needed

    Installing a new ignition switch for 1983 200 hp mercury black max this afternoon. Have part number 87-88107a 5 with heat gun solder butt connectors. I am not mechanical at all and this is a reach for me. Is there anything that I should be looking out for. Installing into Commander Side...
  4. B

    high altitude carb jetting 85 200 Black Max

    I have an 85 200 Black Max, serial #A124938. Engine is running very rich, came from a lower altitude 5,500 feet to a high altitude 8500 feet. Engine smokes, idles high, bogs down when laying on the throttle. Current jets are as follows, Intermediate Jet .056, Main/Float Jet .078, Pilot/Air...
See more
Top