I need to replace the oil seals under my water pump. Do I need to pull the bearing housing to get them out or can I just use my seal puller and pull them out as it is? How do I get the housing out if I need to pull it? I have the Seloc manual but it's not much help.
Thank you!
I have been trying to follow my Solec Manual but it is hard to see some pics. The inlet piece with the spring that sits under the float, does the spring sit up towards the float or does the point? Secondly there is a brass screw on top of the carb close to the black throttle piece. Does that...
I have a 1984 7.5 Mercury with a serial # of 6546130 which has been running on 1 cylinder. When I went to test the coils I noticed the 2 white striped wires; 1- blue/white and the other green/white were attached at the 2 separate coils in different positions. The blue/white wire was fastened on...
Replacing the impeller on my motor. How do you get the key pin to stay in place while putting the water pump housing onto the drive shaft? Does the hump on my key pin face in or away from the drive shaft?
Thank you,
Randy