Recent content by ARGYLL

  1. A

    MID 1990S YAMAHA 90HP 2 stroke cdi (any ideas )

    Hi Again Everbody Someone Must Know Come I Need Some Help Please, Engine Will Only Run When In Get You Home Mode I.e When I Disconnect The Yellow Cable Below The Cdi Unit What Should I Be Checking For Faults
  2. A

    yamaha 90HP 2 STROKE CRANK SENSOR

    Engine Will Fire Up Then Shut Down .then When I Disconnect Crank Posistion Sensor Engine Will Fire Up And Run. Q1 Is It Bad For It To Run With This Sensor Disconnected Q2 Why Is The Sensor Shutting Down The Engine I Know The Sensor Is Not Faulty Any Help Alasdair
  3. A

    yamaha 60hp 89year

    seem to have problem with gas assit tilt do they need refilled or rebuilt or renewed.it looks perfect but offers no assistance when tillting engine.I think you are ment to press red lever and engine should lift with ease but what would I know I think its broken.
  4. A

    suzuki dt 60 squeals

    Hi I have a suzuki DT 60 that squeals when rpm is being reduced. apart from that it runs quite well.any ideas .it sounds like a vacum sort of squeal
  5. A

    lost keys

    Any ideas on how to start engine with out key . has pull start do i need to have ignition on or can it start with out
  6. A

    WATER IN CYLINDER

    hi there help needed. i seem to be getting water into bottom cylinder of a 50hp 1991 force outboard. runs ok then starts to cough and splutter slow it down to tick over misfirtes and stops. removed plugs bottom plug has a gery mist like oil water mix on it.where do start to remove head and...
  7. A

    WATER IN CYLINDER

    hi there help needed. i seem to be getting water into bottom cylinder of a 50hp 1991 force outboard. runs ok then starts to cough and splutter slow it down to tick over misfirtes and stops. removed plugs bottom plug has a gery mist like oil water mix on it.where do start to remove head and...
  8. A

    cooling water

    HI all help needed 1991 force outboard 50 hp.seem to be getting water into the bottom cylinder Q.water getting in between head gasket or at exhaust port which one should I check first
See more
Top