Wiring Second RMP guages for second station Evinrude ETEC 225
I have a second station and would like to install a second RPM gauge for each engine. I have installed aftermarket Teleflex gauges that are wired to my 2010 Evinrude Etec 225's (2). Everyone I have spoken to is not sure if this is possible (in essence, daisy-chaining the sender/sensor info from the engine). I would think we could simply 'extend' the signal from the first set of gauges, but not sure this is possible or feasible (signal loss/wiring challenges). Anyone every done this type of thing or have ideas on where I may be able to find out info. on this sort of arrangement?
any help would be greatly appreciated. tight lines.