If anyone can help me with wiring diagram to hook up my tilt & trim?
I just replaced my outboard merc, to a evinrude. the merc,had the thing on the side of the motor. The evinrude has a box that goes in the boat the wires
hook to. any help please.the boat is a 88 model and the evinrude is early 80"s
I seen your diagram PT&T and thats the way I hooked it up but it powers one way but not the other way. i better start at the begining. The PT&T worked when I got it the man had wires everwhere. After fixing the leaks I removed some wires that the diagram didn't have. the motor wasdn't good so I had it rebuilt. I checked the motor to see if it was working and it is. But when I connect the wires to the junction box (where the silenoid is) the motor work one way. the wires are connected just like the diagram. I had to put a three way switch. 1 is up 2 is off 3 is down.
Oh I forgot the engine starter quit working.
I found on another site forum a two solenoid hook up. Can I switch my single solenoid to a two solenoid system?
Last edited by tinner45; August 2nd, 2009 at 04:37 PM.
Reason: Didn't finsh my post some how it posted before I was done