Please note this thread has been inactive for 90 days. For the best results, please start a new thread.
June 2nd, 2010, 08:47 PM
#1
[OP]
Cadet
evinrude 150hp primer ball
i have 150 hp intruder should the primer ball stay hard well running or get soft
June 2nd, 2010, 08:53 PM
#2
Captain
Re: evinrude 150hp primer ball
It will not stay hard because fuel is being drawn through it by the pump.
It should not be sucked down to a partly flattened state either. That would indicate restriction in the fuel pick up from the tank or lack of tank venting.
Similar Threads
By mixin in forum Johnson & Evinrude Outboards
Replies: 9
Last Post: October 3rd, 2009, 09:30 PM
By abomb in forum Johnson & Evinrude Outboards
Replies: 9
Last Post: September 11th, 2008, 06:30 PM
By tie_one_on in forum PWC (Jetskis, Waverunners, etc.)
Replies: 1
Last Post: September 5th, 2008, 11:21 PM
By tudiebird in forum Johnson & Evinrude Outboards
Replies: 9
Last Post: August 1st, 2007, 10:36 PM
By blitzman17 in forum Johnson & Evinrude Outboards
Replies: 5
Last Post: August 4th, 2004, 01:16 PM
iboats Forum Directory - Over 100,000 forum posts organized by topic