Please note this thread has been inactive for 90 days. For the best results, please start a new thread.
Results 1 to 2 of 2
  1. #1
    Cadet
    Join Date
    Sep 2003
    Location
    England
    Posts
    13

    Default 1981 JOHNSON 25HP SHEAR PIN

    I can't find a shear pin on this motor! Does anybody have any ideas? Is there an alternative system to avoid damage caused by prop contact?I am baffled!Paul Duggins

  2. #2
    Supreme Mariner
    Join Date
    Sep 2003
    Location
    Kitty Hawk NC
    Posts
    20,072

    Default Re: 1981 JOHNSON 25HP SHEAR PIN

    Hello I think all the 81-83 25 HP OMC were spline drive. if your prop shaft is splined then there is no shear pin. the prop has a rubber hub that might slip. good luck and keep posting
    no tech questions by PM, they wont get answered.
    you have to be trusted by the people that you lie to .

Similar Threads

  1. problems starting 25hp Johnson 1981
    By jasper60103 in forum Johnson & Evinrude Outboards
    Replies: 12
    Last Post: September 20th, 2009, 04:17 PM
  2. 1981 vs 1985 Johnson 25hp motor
    By cvtech1 in forum Johnson & Evinrude Outboards
    Replies: 8
    Last Post: August 26th, 2009, 08:50 PM
  3. 1981 25HP Johnson throttle problem
    By cvtech1 in forum Johnson & Evinrude Outboards
    Replies: 6
    Last Post: August 19th, 2009, 08:30 PM
  4. 1981 25hp Johnson Lower Unit
    By hogfan1979 in forum Johnson & Evinrude Outboards
    Replies: 3
    Last Post: August 21st, 2008, 03:02 PM
  5. 78 Johnson 25hp hit limb under water... no shear pin... help!
    By jkduab in forum Johnson & Evinrude Outboards
    Replies: 10
    Last Post: May 26th, 2006, 01:01 PM
  1. iboats Forum Directory - Over 100,000 forum posts organized by topic