Please note this thread has been inactive for 90 days. For the best results, please start a new thread.
June 30th, 2009, 12:26 PM
#1
[OP]
Cadet
1967 johnson 100 hp ignision conversion
my 1967 johnson has had the power pack remover and they added points to the motor. and remover the sensor. the point they put on has about 1/4 inch pivet base on the bottom can anyone tell me what that point is?
please help!
June 30th, 2009, 12:36 PM
#2
Supreme Mariner
Re: 1967 johnson 100 hp ignision conversion
I believe that you're asking what the point gap is.
Your engine would have the distributor located at the rear portion of the engine, and that type would have a point setting of .020 .
Similar Threads
By Ejgonter in forum Johnson & Evinrude Outboards
Replies: 3
Last Post: June 1st, 2009, 08:38 PM
By Ejgonter in forum Johnson & Evinrude Outboards
Replies: 5
Last Post: May 28th, 2009, 11:46 PM
By Ejgonter in forum Johnson & Evinrude Outboards
Replies: 3
Last Post: May 11th, 2009, 06:44 PM
By jasonneal in forum Johnson & Evinrude Outboards
Replies: 18
Last Post: August 13th, 2008, 11:11 PM
By michael4ever in forum Johnson & Evinrude Outboards
Replies: 2
Last Post: January 18th, 2006, 08:09 AM
iboats Forum Directory - Over 100,000 forum posts organized by topic