Hi,
I have a little used Mercury 3.6 (1982 vintage).
It runs well but makes an oily mess over the water.
I discovered that there's a fitting in the crankcase with a plastic tubing hanging.
I can't find where it must be connected.
Of course, there is a pulsating pressure out of the fitting since it's right on the crankcase.
The carb is a float type carb (old motorcycle type)
ANY HELP WILL BE VERY WELCOMED !
(If you need pictures I think I can post them in a few days)
I have a little used Mercury 3.6 (1982 vintage).
It runs well but makes an oily mess over the water.
I discovered that there's a fitting in the crankcase with a plastic tubing hanging.
I can't find where it must be connected.
Of course, there is a pulsating pressure out of the fitting since it's right on the crankcase.
The carb is a float type carb (old motorcycle type)
ANY HELP WILL BE VERY WELCOMED !
(If you need pictures I think I can post them in a few days)