PowerAddict
Chief Petty Officer
- Joined
- Aug 8, 2007
- Messages
- 418
So as you my know, I'm trying to make a 290 and 280 drive work.
I read the manual on shimming the vertical shaft bearing into the race on the intermediate housing. (a 280 lower on a 290 intermediate housing in my case) The process is simple enough, but the tool required is something I obviously don't' have. I probably know the answer to this, but are there any tricks around the specialty tool? Can you just look at the wear pattern in the bearing?
Volvo service is limited around here for drives this old, thats all.
Thanks,
Matt
I read the manual on shimming the vertical shaft bearing into the race on the intermediate housing. (a 280 lower on a 290 intermediate housing in my case) The process is simple enough, but the tool required is something I obviously don't' have. I probably know the answer to this, but are there any tricks around the specialty tool? Can you just look at the wear pattern in the bearing?
Volvo service is limited around here for drives this old, thats all.
Thanks,
Matt