There are two problems I can forsee in using the existing holes: they are already used for thumb screws to secure the pull out light board poles and secondly their size. I think the holes are approximately 16mm diameter so the eye bolts would have to be huge which might mean I can't get the correct sized spanner inside to hold the nut. If I went to a smaller size bolt say 12mm then would the slop be too much?
When I get chance I have a good look over it and measure different options up. Will report back.
Thanks for all the suggestions though, never expected this much great help.
When I get chance I have a good look over it and measure different options up. Will report back.
Thanks for all the suggestions though, never expected this much great help.