edgexswitchback
Cadet
- Joined
- Jun 3, 2016
- Messages
- 8
OK. I got this setup uber cheap. It's not pretty, but gets me to where the fish are. I'm sure by the pictures you can tell that the existing rollers are inadequate. When I try to load it, it would rather go to one side or the other rather than down the middle. An uneven landing makes it even worse. I also need to improve the side bunk setup as they like to bend when the boat bumps into them. Any suggestions that won't break the bank? I can weld in additional metal if needed. Thanks!