AVeryHungryHobo
Cadet
- Joined
- May 9, 2016
- Messages
- 26
purchased a 15ft lund with 40hp evenrude and console steering, came on a very small trailer, the trailer needs almost every roller replaced in the middle, and the two I'm not sure what to call it, and explaination of everything id need to know would be great! but say theres the trailer, tongue-winch-middle rollers support V of hull- and a good 6 ft of support on either side of middle rollers-- barely fits inbetween the two spines under the boat making it very difficult to land the boat squarely on the trailer, and any tips or advice for landing a boat, and or how to install guides rollers and anything that may help so the rear end of the boat doesn't sway when trying to load would be vermuch appreciated , I have one arm and its quite the challenge to keep the boat straight while cranking it up. also where or how do I find the rollers I need to replace, and as for a transom saver, is it okay to have a moter without electric tilt supported by one? the rod that goes from the prop to the trailer when hauling. not sure what else I can think of, stuck at work while dreaming about opener.