93baylinerjazz
Seaman Apprentice
- Joined
- Jul 18, 2010
- Messages
- 30
I was ready to take it out for the fist time tomorrow and found the steering cable was frozen (when i went to connect it).
I cannot free up the cable (at least not yet) so will most likely have to purchase another. My question is has anyone had any trouble sourcing the correct part number for a 93 jazz? I have found this thread http://forums.iboats.com/showthread.php?t=320069 but also came across this one http://www.baylinerownersclub.org/forum/showthread.php?t=40402 and am a little concerned.
I too believe I have a 4300bc control cable as my steering cable. It looks very similar to this on both ends: http://www.seattlemarine.net/productcart/pc/viewPrd.asp?idproduct=15008&idcategory=0
This does not appear to be the same cable that the part numbers in the first thread support. I do have an older Jazz (with the ring electrical connectors), and my steering tower is just a sheet of plate aluminum.
I have been unable to locate any part numbers on my existing cable.
Has anyone ever had any experience with this? Does the ride plate have to be pulled to change out the cable?
I am half tempted to take it to the marina to avoid the frustration of ordering and returning multiple cables until i get the right one.
Any advise/information/snide remarks are greatly appreciated.
I cannot free up the cable (at least not yet) so will most likely have to purchase another. My question is has anyone had any trouble sourcing the correct part number for a 93 jazz? I have found this thread http://forums.iboats.com/showthread.php?t=320069 but also came across this one http://www.baylinerownersclub.org/forum/showthread.php?t=40402 and am a little concerned.
I too believe I have a 4300bc control cable as my steering cable. It looks very similar to this on both ends: http://www.seattlemarine.net/productcart/pc/viewPrd.asp?idproduct=15008&idcategory=0
This does not appear to be the same cable that the part numbers in the first thread support. I do have an older Jazz (with the ring electrical connectors), and my steering tower is just a sheet of plate aluminum.
I have been unable to locate any part numbers on my existing cable.
Has anyone ever had any experience with this? Does the ride plate have to be pulled to change out the cable?
I am half tempted to take it to the marina to avoid the frustration of ordering and returning multiple cables until i get the right one.
Any advise/information/snide remarks are greatly appreciated.