I purchased Solas Amita #1511-145-19 Aluminum Boat Propeller,
When removing my current prop, it is a flo torque thrust master II design.
The new Solas will fit the shaft, but I cannot tighten the hub nut to 55lb torque, without locking the propeller,
to where it does not turn freely, or as free as the original.
My question is do I have the correct propeller for this design?
If I do, how do I tighten the nut and allow the propeller to turn freely?
When removing my current prop, it is a flo torque thrust master II design.
The new Solas will fit the shaft, but I cannot tighten the hub nut to 55lb torque, without locking the propeller,
to where it does not turn freely, or as free as the original.
My question is do I have the correct propeller for this design?
If I do, how do I tighten the nut and allow the propeller to turn freely?