• If this is your first visit to the iboats.com Boating Forums, be sure to check out the FAQ. To post a question or comment, begin by signing up. To start viewing messages, select the forum that you want to visit from the selection below.
  • ALL iboats Forum Members and Guests:
    To show our appreciation for your participation in the Forums, we're offering an exclusive Forums-only discount good for an additional 5% off your iboats.com order for a limited time.
    To redeem, simply call our Customer Service Team at 800-914-1123 (Open M-F, 9am - 8pm Eastern Time) and mention the Forums 5% off discount. Offer excludes engines, trolling motors, and electronics.

Announcement

Announcement Module
Collapse
No announcement yet.

replacing the rubber bushing in my prop??

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts


  • replacing the rubber bushing in my prop??

    I have a 1978 25hp evenrude with a non-thru exhaust 13 spline prop. I found out that my rubber bushing inside the prop is wore out and under a load starts to slip. My question is can I replace this bushing myself or do u have to replace the whole prop? Thanks for any answers or advise.


  • #2
    Re: replacing the rubber bushing in my prop??

    Take or send it to a prop shop & they will re-hub it for you.

    Comment



    • #3
      Re: replacing the rubber bushing in my prop??

      Agreed. Prop shop is the best idea. Half the cost of a new prop.

      Comment



      • #4
        Re: replacing the rubber bushing in my prop??

        I had a feeling that was what was going to be said lol. I just didn't know if there was a way to replace that hub yourself to save some money. But I guess I will have to get hold of the shop here in town

        Comment

        Working...
        X