• If this is your first visit to the iboats.com Boating Forums, be sure to check out the FAQ. To post a question or comment, begin by signing up. To start viewing messages, select the forum that you want to visit from the selection below.
  • ALL iboats Forum Members and Guests:
    To show our appreciation for your participation in the Forums, we're offering an exclusive Forums-only discount good for an additional 5% off your iboats.com order for a limited time.
    To redeem, simply call our Customer Service Team at 800-914-1123 (Open M-F, 9am - 8pm Eastern Time) and mention the Forums 5% off discount. Offer excludes engines, trolling motors, and electronics.

Announcement

Announcement Module
Collapse
No announcement yet.

corner molding for pontoon

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts


  • corner molding for pontoon

    I have a 89' pontoon sun tracker need {corner caps right angle and nose**, any web sites reccomendations to purchase from.


  • #2
    Re: corner molding for pontoon

    You may try an older marine supply store near you.

    Although I can not vouch for them, you may want to look at -
    http://www.restorepontoon.com/pontoo...rdware-c10.htm

    or

    http://www.pontoonspecialists.com/c-...p-casting.aspx
    2009 Neptoon 25TT Sport Sun Lounger
    150 Honda

    Older than dirt and just about as active.

    Comment



    • #3
      Re: corner molding for pontoon

      Tracker is still in business. I would order from them.

      TrackerMarine.com

      Comment



      • #4
        Re: corner molding for pontoon

        Many suppliers carry them, West Marine, Pontoon Stuff, probably iboats, etc. You can probably find a close match or replace all 4.
        Ray

        Never take instruction from a guy with missing fingers.

        Comment



        • #5
          Re: corner molding for pontoon

          iboats of coarse and they have the best price!
          GO IRISH!!!!

          Comment



          • #6
            Re: corner molding for pontoon

            I have a 89 Bass Tracker Pontoon that i have just completed a complete rebuild and I contacted my local marina and they ordered the stock corners from Tracker...it has been about 8 months ago but I think they were only around $50 for all four....Good Luck

            Comment



            • #7
              Re: corner molding for pontoon

              I have the same issue. the sites listed above don't have the right size. I was thinking if I need to take a hacksaw to a set to get them to fit. What are they made of? can you cut them to size?
              Chris

              Up a river without a DAM lake!

              Comment



              • #8
                Re: corner molding for pontoon

                Their made of black black plastic.

                Comment



                • #9
                  Re: corner molding for pontoon

                  have a 2000 suntracker party barge i got my cornor caps from www.everythingpontoon.com fit perfectly

                  Comment



                  • #10
                    Re: corner molding for pontoon

                    I went to a fab shop and had a new front piece made out of thick alum.

                    Comment

                    Working...
                    X