rocknreel20
Recruit
- Joined
- May 21, 2012
- Messages
- 1
I have an old 70's Valco 13ft aluminum V-Hull.
Over the years rivets that supported the middle bench seats were welded over.
The bottom of the boat now flexes quite a bit from no support of the bench seat.
Looking for ideas on how to apply new support for the boat bottom?
I applied alot of silicone awhile back but it didnt work that well there is maybe an inch or two clearance.
Thanks for the help
Over the years rivets that supported the middle bench seats were welded over.
The bottom of the boat now flexes quite a bit from no support of the bench seat.
Looking for ideas on how to apply new support for the boat bottom?
I applied alot of silicone awhile back but it didnt work that well there is maybe an inch or two clearance.
Thanks for the help