Re: Installing depth Finder Tranducer
The guy I bought my first boat from installed a new transducer right before I got it from him. He explained the process, which was pretty simple. You just want to get it attached to the inside of the hull near the stern as close to the centerline as possible and as flat as possible. There is an epoxy compound that you can get for relatively cheap that you use to install it in. You just need to be sure that there aren't any air bubles in the epoxy as that can cause it not to work properly. Attache the wiring, and you should be good to go. And I'm assuming you are talking about a fiberglass bowrider here. If you're doing an exterior stern mount, this would obviously not apply.