Polar 2005 2 stroke 150 Yamaha

polar05

Seaman
Joined
Dec 14, 2009
Messages
53
Have hot battery, lights on console and switches. Have no power to motor, electric choke, trim. When ignition is turned on gage's don't move.
 

robert graham

Admiral
Joined
Apr 16, 2009
Messages
6,908
Remove/check/clean/grease all those cables and connections...humid marine environment can cause corrosion where it's not visible or obvious....
 

polar05

Seaman
Joined
Dec 14, 2009
Messages
53
Vice Admiral thank you for your information. Once again this technical support has been a success. It was just a simple positive cable from the back of the boat to the motor. Trouble shot it with a simple test light. The ground was good the positive was bad. I shall replace both once I figure out how to get them through this black hose.
 
Top