rothfm
Ensign
- Joined
- Sep 26, 2006
- Messages
- 913
I'm working on getting a factory manual, was hoping someone could point me to a couple specs in the meantime.
I'm usually on the Johnson/Evinrude board, my first Yamaha. I bout this motor for $75 bucks! Guy said no spark, otherwise its really like new condition and no Salt. Couldnt pass it up.
In testing, I first had spart, then not, then spark, no rhyme to reason. No obvious physical issues. The Previous owner has a new dual coil, wires, and plugs on it already. about 130psi on both holes.
Does anyone have the spec for ohm'ing out the "stator" leads , if that is what it is called on this engine. Or what the same might be from the "CDignition" box leads (which I'm assuming is like a powerpack")
Or anything else to look into, until I can get a manual. I hope the Yamaha manuals are as good as the OMC manuals.
Thanks
I'm usually on the Johnson/Evinrude board, my first Yamaha. I bout this motor for $75 bucks! Guy said no spark, otherwise its really like new condition and no Salt. Couldnt pass it up.
In testing, I first had spart, then not, then spark, no rhyme to reason. No obvious physical issues. The Previous owner has a new dual coil, wires, and plugs on it already. about 130psi on both holes.
Does anyone have the spec for ohm'ing out the "stator" leads , if that is what it is called on this engine. Or what the same might be from the "CDignition" box leads (which I'm assuming is like a powerpack")
Or anything else to look into, until I can get a manual. I hope the Yamaha manuals are as good as the OMC manuals.
Thanks