Hi all,
I'm hoping someone has done this before. I dismantled my tilt / trim electric and hydraulic pump and managed to get the whole thing back together except for 2 x small ball bearings that sit somewhere around the valve body.
There are two holes that are surrounded with rubber o-rings on the under side of the valve body and I dropped the ball bearings into this area... it seemed like the only logical Place these could do.
Does anyone have a diagram or perhaps has rebuilt one of these previously and have some photos of information they can lend a hand?
I checked the manual, it doesn't go into this much detail it only lists the valve body as a complete part.
Any help appreciated.
Cheers
Glen
I'm hoping someone has done this before. I dismantled my tilt / trim electric and hydraulic pump and managed to get the whole thing back together except for 2 x small ball bearings that sit somewhere around the valve body.
There are two holes that are surrounded with rubber o-rings on the under side of the valve body and I dropped the ball bearings into this area... it seemed like the only logical Place these could do.
Does anyone have a diagram or perhaps has rebuilt one of these previously and have some photos of information they can lend a hand?
I checked the manual, it doesn't go into this much detail it only lists the valve body as a complete part.
Any help appreciated.
Cheers
Glen