classicevinrude
Cadet
- Joined
- Jul 29, 2008
- Messages
- 25
Hello all,
We are finishing up a classic Sea Craft boat that has a 1989 200hp Yamaha on the transom. This boat has the two digital gauges. All of the color coded connectors and wires are properly connected.
However, when the key is turned to on, the trim and tilt motor runs but nothing else activates. The engine will not crank but there is 12 volts at the solenoid but nothing at the starter.
I have been tracing everything as per the wiring diagram but am not really finding anything out of order. Any suggestions would be greatly appreciated. If you need any other engine information or pictures, I would be happy to supply them. Thank you very much for the assistace. Forrest
We are finishing up a classic Sea Craft boat that has a 1989 200hp Yamaha on the transom. This boat has the two digital gauges. All of the color coded connectors and wires are properly connected.
However, when the key is turned to on, the trim and tilt motor runs but nothing else activates. The engine will not crank but there is 12 volts at the solenoid but nothing at the starter.
I have been tracing everything as per the wiring diagram but am not really finding anything out of order. Any suggestions would be greatly appreciated. If you need any other engine information or pictures, I would be happy to supply them. Thank you very much for the assistace. Forrest