I am putting my 1996'ish Yamaha 150 back together after breaking the crankshaft and have a question.
I have a used crankshaft and need to know if it needs to be mic'd or machined?
I had to replace the two center main bearings (brand new) but was able to re-use the two end bearings.
2 stroke and I'm not sure of the year, 95 or 96
Thanks !!
I have a used crankshaft and need to know if it needs to be mic'd or machined?
I had to replace the two center main bearings (brand new) but was able to re-use the two end bearings.
2 stroke and I'm not sure of the year, 95 or 96
Thanks !!
Last edited: