Yamaha 200hp V6 2 stroke

curtisvitoria

Recruit
Joined
Aug 9, 2010
Messages
2
Hi new to the forum, just finished giving the motor a tune up(93 V6 precision blend 200hp 2stroke). Running the boat in the driveway, when it seemed I may have run out of fuel.After putting in some fuel, boat turns over just fine and stumbles. At this point I changed my fuel/water seperator which looked to be dirty anyway. Bled fuel line of air and commenced to start, nothing. Same stumble.... she wont fire up? Any sugg? Im hoping the pump isnt shot? Thanks!
 

curtisvitoria

Recruit
Joined
Aug 9, 2010
Messages
2
Re: Yamaha 200hp V6 2 stroke

Well after spraying some cleaner in all 3 carbs ,turning over the engine until it ran for longer periods each time, boat finally started. Stalled out a few times, but finally held an idle. Ran for about 20 min, now it seems back to normal.
 

99yam40

Fleet Admiral
Joined
Sep 7, 2008
Messages
8,874
Re: Yamaha 200hp V6 2 stroke

pumping primer bulb should put fuel into the carb bowls, pushing right through the pumps. May need to clean carbs if filter was dirty
 
Top