How do you get to the trim switch on the Yamaha 6X0 remote??

Louie1956

Cadet
Joined
Mar 20, 2010
Messages
24
Hi- I've searched hi and low to no avail. I have a 6X0-48206-12-00 remote that has a trim switch mounted inside the top piece of molded plastic. The up is intermittent and I can?t figure out how to get to it. No screws anywhere.
Any help would be greatly appreciated.
Louie...
 

rodbolt

Supreme Mariner
Joined
Sep 1, 2003
Messages
20,066
Re: How do you get to the trim switch on the Yamaha 6X0 remote??

remove the rubber cap covering the center of the handle.,remove the plate , handle should wiggle off now.
 

Louie1956

Cadet
Joined
Mar 20, 2010
Messages
24
Re: How do you get to the trim switch on the Yamaha 6X0 remote??

Thanks much. Just took the nudge as I was afraid of what springs may go flying etc.
Remove the washer- pull handle off- pop red cover off of the red neutral slide piece- remove screw that holds neutral slide and remove slide-remove screw that holds gray plastic top piece- remove screw that secures switch-cut or pull back rubber around switch body- unsnap the switch- take apart and clean contacts- re-assemble- wallah!
10 minute job when you know what your doing.

Thanks again..
Louie..
:rolleyes:
 
Top