Yamaha 200HP reassembly

Joined
Aug 2, 2006
Messages
21
Getting ready to reassemble two 1990 model 200ETXD's. Steering arms rusted out on the original motors. I pulled the power heads and dropped the lower units. Got two used midsections, parts, gaskets, and now ready to start the reassembly process.


Does anyone have any tips or advice for this type of project? I have the Yamaha shop manual but looking for any advice that will save time and/or result in a better installation.


Thanks in advance.
 
Joined
Aug 2, 2006
Messages
21
Two specific questions for this:

1. Does anyone have a recommendation for gasket sealant between the powerhead and midsection?

2. Should there be any sealant between the lower unit and the midsection? I assume not since there is no gasket but wanted to ask.

Thanks!
 
Top