smassey22180
Petty Officer 1st Class
- Joined
- Apr 15, 2013
- Messages
- 210
I took my new to me boat out this weekend and temp gauge did not move above 100. IR thermometer said engine temp was good. My ohm meter say the sensor is an open circuit both hot and cold. What is the proper way to test?
Also, I grounded the tan wire and the alarm beeped but the gauge did not move (engine off). I tested the gauge and grounded the S post and it went to full hot. Does the wire to the gauge pass through the alarm somehow?
Thanks
Also, I grounded the tan wire and the alarm beeped but the gauge did not move (engine off). I tested the gauge and grounded the S post and it went to full hot. Does the wire to the gauge pass through the alarm somehow?
Thanks
Last edited: