Hey guys,
I'm in the middle of changing out the bellows on a pair of 2000 5.7GS with SX drives. I want to change the trim sending units at the same time, but am finding it very difficult to access the retaining clip holding the wires in place, in the transom assembly in behind the engine.
Anyone have any tips to share?
Thanks!
I'm in the middle of changing out the bellows on a pair of 2000 5.7GS with SX drives. I want to change the trim sending units at the same time, but am finding it very difficult to access the retaining clip holding the wires in place, in the transom assembly in behind the engine.
Anyone have any tips to share?
Thanks!