BigBobsBigBobbingBogBoat
Seaman Apprentice
- Joined
- Jul 11, 2010
- Messages
- 47
Hey Guys,
I'm refurbing an old volvo penta 280 outdrive. A major issue was that the lower vertical shaft has been sheered off clean very close to where it's enclosed within the lower unit housing. (See upside-down pic below!). (I've taken picks of it from the top and bottom)
I've pulled the prop shaft and removed the nut, but that old vertical shaft is really stuck to that gear, and since I don't have much to grab on the top to pull with (since it's sheared off) I'm stuck.
Any thoughts to get the thing out?
I'm refurbing an old volvo penta 280 outdrive. A major issue was that the lower vertical shaft has been sheered off clean very close to where it's enclosed within the lower unit housing. (See upside-down pic below!). (I've taken picks of it from the top and bottom)
I've pulled the prop shaft and removed the nut, but that old vertical shaft is really stuck to that gear, and since I don't have much to grab on the top to pull with (since it's sheared off) I'm stuck.
Any thoughts to get the thing out?