I have a 1990 dpa intermediate that needed a new 1.95:1 lower.
Purchased a used 1.95:1 lower and the vertical drive shaft is approx 1 inch shorter than the old shaft which mates the lower to the intermediate.
My question is: can I just get a longer splined sleeve to make this lower work? Or do I not have the correct lower?
I looked at a schematic and I can't see why I can't just get a longer splined sleeve.
Purchased a used 1.95:1 lower and the vertical drive shaft is approx 1 inch shorter than the old shaft which mates the lower to the intermediate.
My question is: can I just get a longer splined sleeve to make this lower work? Or do I not have the correct lower?
I looked at a schematic and I can't see why I can't just get a longer splined sleeve.