ddbyrd3
Petty Officer 1st Class
- Joined
- May 9, 2005
- Messages
- 369
I have a question, I installed a new impeller at the beginning of the season, a new o-ring, and bearing seal. My motor is a 2002 5.0GL-B; but the pump is still leaking water. I even pulled it apart a second time to make sure the seal was seated properly, and the o-ring was not pinched, ect, ect.
If the bearing is bad, will they continue to leak?? And are they difficult to rebuild??
If the bearing is bad, will they continue to leak?? And are they difficult to rebuild??