Rayv@accesscomm.ca
Recruit
- Joined
- Aug 30, 2015
- Messages
- 3
I've traced a non operation trim/tilt problem to the trim motor. When trying to remove the motor I can't figure out how to
Disconnect the four hydraulic lines. I removed the retaining plate but it does not seem to be holding the lines in and there are no
Line nuts on these lines. Was wondering if I have to remove the lines at the cylinders and remove the motor with the lines attached.
My manual is mute on the correct procedure.
Disconnect the four hydraulic lines. I removed the retaining plate but it does not seem to be holding the lines in and there are no
Line nuts on these lines. Was wondering if I have to remove the lines at the cylinders and remove the motor with the lines attached.
My manual is mute on the correct procedure.