I found 2 things about flappers but need some help to not get in a jam. Further steps(What to undo and what to move) to check and remove flappers or how to get out if they did fall out. This what I found: On pics below you will need to enlarge
So do I do this????
1. Undo part 40
2. Undo part 41
3. remove or turn part 27 elbow
4. flapper is just under part 41 rubber?? where flapper is located in pipe 28 ??
5. So does this just unbolt if there? (how do you keep from falling into pipe tie with wire?)
6. if flapper has fallen into pipe what are the steps to get the bits and pieces out? what tricks work. How do I know if flappers are gone before I start? How do I know if I got all the bits out?
My boat is 1995 5 litre ford, Volvo Penta Sx drive... so I assume if they are still there I should take them out before they do fall??
I assume this can all be done in the boat, but will mean some twisting around as I am 6' 2"
Thanks I know it is a lot to ask.ron3033
So do I do this????
1. Undo part 40
2. Undo part 41
3. remove or turn part 27 elbow
4. flapper is just under part 41 rubber?? where flapper is located in pipe 28 ??
5. So does this just unbolt if there? (how do you keep from falling into pipe tie with wire?)
6. if flapper has fallen into pipe what are the steps to get the bits and pieces out? what tricks work. How do I know if flappers are gone before I start? How do I know if I got all the bits out?
My boat is 1995 5 litre ford, Volvo Penta Sx drive... so I assume if they are still there I should take them out before they do fall??
I assume this can all be done in the boat, but will mean some twisting around as I am 6' 2"
Thanks I know it is a lot to ask.ron3033