Mas
Lieutenant Commander
- Joined
- Oct 3, 2006
- Messages
- 1,656
I've been trying to rebuild a Martin 7.5. The lower piston is seized due to water. I was able to pick up another powerhead for cheap...but the pistons were seized as well due to water. I do not know if I've got bad luck or if water entry was a problem with these Martins!?
Question: Where is the "weak spot" for water entry on these motors? during the autopsy I did not see anything obvious.
Any insight from those who know Martins?
MAS
Question: Where is the "weak spot" for water entry on these motors? during the autopsy I did not see anything obvious.
Any insight from those who know Martins?
MAS