power steering cooler

[K.A.P]

Anybody know where I can get a new power steering cooler with water sender on it like this one? Or can I leave the switch off?

 

[achris]

What engine is it from?

 

[Bt Doctur]

Have never seen one like that , whats it from, and what material? brass/bronze can be soldered up or brazed. power steering coolers are usually in the raw water inlet side and the only sensor would be a water pressure sensor

 

[achris]

I suspect that's from a Yamaha 4.3 stern drive, but need the OP to confirm before I move it to the Yammy forum...

 

[Bt Doctur]

Confirmed Achris, yahama equipment ~~1999 V8_5.0_ENG Yamaha Stern Drive POWER STEERING PUMP - OIL COOLER ...

 

[Bt Doctur]

http://www.bing.com/images/search?q...3E59060B570AA9D293C7A0F3CD227&selectedIndex=0

 

[achris]

Confirmed Achris, yahama equipment ~~1999 V8_5.0_ENG Yamaha Stern Drive POWER STEERING PUMP - OIL COOLER ...

http://www.bing.com/images/search?q=...electedIndex=0

So, it's off to the Yammy forum we go...

 

[Capt Ken]

That pressure switch tells the computer on the YEMS engine that it has enough water pressure. Take it to a radiator shop and they can repair it.

 

[K.A.P]

That pressure switch tells the computer on the YEMS engine that it has enough water pressure. Take it to a radiator shop and they can repair it.

Thanks Capt Ken.

 

[K.A.P]

:joyous:

So, it's off to the Yammy forum we go...

Thanks for pointing me in the right direction :joyous: :joyous:

 

[Scott Danforth]

why not repair what you have?

 

[K.A.P]

why not repair what you have?

As suggested by Capt. Ken I will be getting it done tomorrow

 

[K.A.P]

Took it to a radiator shop and they fixed it in five min.

 

[Scott Danforth]

original construction should have been brazed. that looks like a solder repair. I would keep an eye on it in the future.