1986 4.3 Cobra
Bought new alignment tool off of internet. After I put my new engine in and reached the point I needed to check alignment I've had no luck! I finally gave up and just thought I try and put the drive on and with little effort it went right in. After doing some checking I see no way for the alignment tool to work--this is why.
When I check OD of tool it is 1.00", Now the OD of the yoke shaft spline reads 1.10" and the inner splines .95", if I'm reading my MIC right.
So pls tell me if I'm right or wrong. If I'm right I'll just get that part of tool machined down.
Thanks for any help.
Bought new alignment tool off of internet. After I put my new engine in and reached the point I needed to check alignment I've had no luck! I finally gave up and just thought I try and put the drive on and with little effort it went right in. After doing some checking I see no way for the alignment tool to work--this is why.
When I check OD of tool it is 1.00", Now the OD of the yoke shaft spline reads 1.10" and the inner splines .95", if I'm reading my MIC right.
So pls tell me if I'm right or wrong. If I'm right I'll just get that part of tool machined down.
Thanks for any help.