Winterizing a 1981 omc 3.8 and omc stringer 800

Blujay96

Petty Officer 1st Class
Joined
Jul 8, 2009
Messages
310
I have a new to me boat that I need to winterize. I need to find the locations of all the drain points. I have only ever owned mercruisers. Anything special with the omc I should know about. I downloaded the manual in the adults only section, but it was very vague about locations.

This is in a 1981 sea ray v197.
Any help would be great. Thanks

image.jpg
 

Howard Sterndrive

Rear Admiral
Joined
Nov 5, 2008
Messages
4,603
Re: Winterizing a 1981 omc 3.8 and omc stringer 800

there's 4 drains (+1 more if you have power steering)

1 on each manifold
one on each side of the block, just astern of the selectrim mounts- the starboard side between the fuel pump and starter is the toughest to get

remove the plugs and poke wire in all holes.

then you can take either end of the u shaped water pump hose off and tip it to drain
 

Blujay96

Petty Officer 1st Class
Joined
Jul 8, 2009
Messages
310
Re: Winterizing a 1981 omc 3.8 and omc stringer 800

Thanks. What about the outdrive. Does anybody know where to find the factory service manuals.
 

boobie

Supreme Mariner
Joined
Nov 5, 2009
Messages
20,826
Re: Winterizing a 1981 omc 3.8 and omc stringer 800

Check here on I-Boats first and if no luck try Ken Cook in Milwaukee WI.
 

Howard Sterndrive

Rear Admiral
Joined
Nov 5, 2008
Messages
4,603
Re: Winterizing a 1981 omc 3.8 and omc stringer 800

What about the outdrive.
change the gear lube in all 3 compartments
change the clutch compartment lube
store the drive in the full down position so water does not run in the prop and crack the impeller housing
 

Blujay96

Petty Officer 1st Class
Joined
Jul 8, 2009
Messages
310
Re: Winterizing a 1981 omc 3.8 and omc stringer 800

Thanks guys. I am working on it this week. want to make sure I get all the water out.
 

Blujay96

Petty Officer 1st Class
Joined
Jul 8, 2009
Messages
310
Re: Winterizing a 1981 omc 3.8 and omc stringer 800

Okay I was looking over the motor and found a exterior crack in the manifold on the starboard side. Not sure if it would be worth trying to weld or not. I found a used pair for 100 dollars. Haven't been able to look at them yet they are from a 1984 motor. Would they fit
 

Howard Sterndrive

Rear Admiral
Joined
Nov 5, 2008
Messages
4,603
Re: Winterizing a 1981 omc 3.8 and omc stringer 800

1981-1985 3.8's all used the same manifolds.
 
Top