Hey everyone. I have 2 OMC Cobra questions.
First, I see there are prefab holes in the exhaust bellows at the rear most portion of the bellows, there is a lot of gear oil leaking from there. I'm guessing a blown seal or cracked case. I plan on pulling the drive to find out, but I wanted to know if anyone could point me in the right direction as a search came up with not much,
Second, I can lift my drive up and down and the pistons are just flopping around. I'm thinking air in the cylinders, low on oil, or design? Should I be able to lift the drive up when it is in the downwards position? Hydraulic law and physics say no... thoughts?
First, I see there are prefab holes in the exhaust bellows at the rear most portion of the bellows, there is a lot of gear oil leaking from there. I'm guessing a blown seal or cracked case. I plan on pulling the drive to find out, but I wanted to know if anyone could point me in the right direction as a search came up with not much,
Second, I can lift my drive up and down and the pistons are just flopping around. I'm thinking air in the cylinders, low on oil, or design? Should I be able to lift the drive up when it is in the downwards position? Hydraulic law and physics say no... thoughts?