Exhaust manifolds

[ROGNE]

Hey there I've got a 1976 ford 302 190hp with the original omc exhaust manifolds on it and would like to find new ones the exact same but I can not seem to be able to find them the ones that look exactly like the ones on mine are saying there for a small block Gm I'm thinking maybe some one who reads what I am asking here will be kind enough to help me find what I need thank you

 

[bruceb58]

Go down to the OMC (FORD) V8-302 and 351 C.I.D section for the log style manifolds. That will get you the Barr part numbers
http://www.barrmarine.net/omc.html

 

[Scott Danforth]

welcome aboard.

Bruce has you covered.

 

[Redrig]

Do you have the bananas or rear risers ?

I went through this a couple of years ago and put together a thread with my part numbers of how I did it .

it may be of help to you .

http://forums.iboats.com/forum/engi...outdrives/659072-omc-manifold-conversion-ford

 

[ROGNE]

Tried to send you a pic but it didn't work for some reason I'm going to say rear risers

 

[ROGNE]

Not quite sure why it says I am sending you this message at 10:51pm time it's only 8:30pm and so sorry if this is the correct time where you are at

 

[jbcurt00]

Best to ask this here, ROGNE, rather then over in REDRIGS 2+yr old topic:

Your the best that is the exact set up on my motor you don't know how much I appreciate your time and your information and let me tell you I'm a put together by picture so outstanding thank you again if you don't mind me asking where do you think I could find that hole set up right here on iBoats

Pix help
http://forums.iboats.com/forum/forum...pload-tutorial

If you dont have your iboats profile setup for DST and your timezone setup, your post times arent displayed correctly.

Go down to the OMC (FORD) V8-302 and 351 C.I.D section for the log style manifolds. That will get you the Barr part numbers
http://www.barrmarine.net/omc.html

ROGNE, Did you check the site Bruce posted?

 

[Redrig]

So if you have the rear risers , you are NOT going to find any that are new , well you might but you will also pay a fortune for them . Your only choice is to convert to either bananas or the center riser conversion . I wouldn't trust any ebay used manifolds , but that's just me .

I would go with the centers risers for sure .

There are "conversion kits" that you can buy that have everything needed and converting over is fairly straight forward as I laid out in my thread .

here is the parts list right here on iboats .

http://www.iboats.com/Universal-For...8064300--session_id.978344482--view_id.272956