Hi I am in desperate need of help.
After making many beginner mistakes I successfully replaced bellows and shift cable.
In the process the first time I tried to thread the new cable through the transome it got stuck in the flywheel housing. I cut the cable near the flywheel and pulled the cable back out the transome from outside the boat leaving about 6 inches of the cable outside the flywheel.
I read somewhere that I could just leave it there but when I started the engine I now hear a clicking noise.
Has anyone had this issue? I am at the end of my patience. Sore with bruises and cuts all over myself.
Any advise would be welcome.
Thanks!
After making many beginner mistakes I successfully replaced bellows and shift cable.
In the process the first time I tried to thread the new cable through the transome it got stuck in the flywheel housing. I cut the cable near the flywheel and pulled the cable back out the transome from outside the boat leaving about 6 inches of the cable outside the flywheel.
I read somewhere that I could just leave it there but when I started the engine I now hear a clicking noise.
Has anyone had this issue? I am at the end of my patience. Sore with bruises and cuts all over myself.
Any advise would be welcome.
Thanks!