canoemang
Petty Officer 1st Class
- Joined
- Apr 9, 2011
- Messages
- 350
There are 2 bolts on the front of my 115 Merc 6 cylinder..
One between carb 1 and 2 and one between carb 2 and 3. I noticed one was loose and the flange/keeper was locked down.. I tightend it back up. The shop who did the rebuild must not have put the flanged keeper down..
Should i have any concerns about it being loose?
Labeled as "SCREW, CENTER MAIN BEARING LOCKING"
# 18 on link below..
LINK
Any info would be great.
One between carb 1 and 2 and one between carb 2 and 3. I noticed one was loose and the flange/keeper was locked down.. I tightend it back up. The shop who did the rebuild must not have put the flanged keeper down..
Should i have any concerns about it being loose?
Labeled as "SCREW, CENTER MAIN BEARING LOCKING"
# 18 on link below..
LINK
Any info would be great.